Clevo M860TU Bedienungsanleitung PDF herunterladen (Seite 32)

Disassembly

2 - 6 Removing the Hard Disk Drive

2.Disassembly

Removing the Hard Disk Drive

The hard disk drive is mounted in a removable case and can be taken out to accommodate other 2.5" serial (SATA) hard

disk drives with a height of 9.5mm (h). Follow your operating system’s installation instructions, and install all necessary

drivers and utilities (as outlined in Chapter 4 of the User’s Manual) when setting up a new hard disk.

Hard Disk Upgrade Process

1. Turn off the computer, and turn it over and remove the battery (page 2 - 5).

2. Locate the component bay cover and remove screws - .

3. Carefully (a fan and cable are attached to the under side of the cover) lift up the bay cover .

4. Carefully disconnect the fan cable , and remove the cover .

5. The hard disk assembly cover will be visible at point on the mainboard.

Figure 2

HDD Assembly

Removal

a. Remove the screws.

b. Remove the cover and lo-

cate the hdd.



8. Component Bay

Cover

•7 Screws



Fan Cable

Make sure you recon-

nect the fan cable

before screwing down

the bay cover.

a. b.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 99 100

Keine Kommentare

Clevo M860TU Bedienungsanleitung Seite 32